18
Set up the printer
Step 5: Set up the printer
You’ve unpacked your new Optra W810,
chosen an appropriate location for it, and
set up its standard and optional drawers.
Now you’re ready to connect the printer
to the drawers and install supplies.
CAUTION!
If you are connecting the
printer to an optional drawer sometime
after initial printer setup, turn the printer
off and unplug the power cord before
continuing.
The following table lists page numbers
where you can find instructions for con-
necting the printer to the drawers you’ve
set up. Find your drawer configuration,
and then go to the page listed to begin
setting up your printer.
If you are attaching the printer to … See page …
One 500-sheet drawer (standard configuration) 19
Two 500-sheet drawers 22
A 500-sheet drawer and a 2500-sheet drawer 25
To Next Page
Loading...
