70
Install the duplex option
9
Make sure the connector cords
are completely inside the
socket compartment.
10
Reinstall the connector cover.
If the connector cover is difficult to
reinstall, tuck the cords
very
tightly
inside the socket compart-
ment and try again.
Adjusting the side
door tension
After you install the duplex option, you
must adjust the tension of the wire that
supports the side door and the weight of
the newly attached duplex unit.
If you’ve already installed a 10-bin mail-
box or a finisher, you’ll need to separate
it from your printer before following the
steps that begin on page 71.
Note:
Be sure to return the tension
adjuster to its original position if you
remove the duplex option from the
printer.
To Next Page
Loading...
