100
Set up the optional finisher
Step 9: Set up the
optional finisher
The Optra W810 supports a 2500-Sheet
Finisher Option that adds hole punching
and stapling functions to your printer’s
output capabilities.
Before you can attach the finisher, how-
ever, you must make sure your printer is
the correct height to align with the height
of the finisher. You can do this by config-
uring the printer with one of the following
Lexmark options:
•
A 2500-sheet drawer option
•
A combination of a 500-sheet
drawer option
and
an appropriate
printer stand
•
A printer stand of the appropriate
height
Contact Lexmark for more infor-
mation about the printer furniture
available for the Optra W810
printer.
The figure to the left shows the printer
correctly aligned with the finisher.
Note:
The illustrations in this section
show a printer with an optional
2500-sheet drawer attached.
To Next Page
Loading...
