28
Set up the printer
Removing packaging
from the trays
The illustrations in this section show a
printer configured with the three stan-
dard drawers. Your printer may look
different, depending on the options you
attached.
1
Pull open tray 1 and remove the
foam cushioning, as shown.
2
Close tray 1.
3
Pull open tray 2 and remove the
foam cushioning, as shown.
4
Close tray 2.
5
Repeat steps 3 through 4 to
remove packaging from tray 3.
If you installed an optional
500-sheet drawer, repeat steps 3
through 4 to remove packaging
from tray 4.
To Next Page
Loading...
