104
Set up the optional finisher
Warning!
Do not move the finisher by
pushing on its output bins. Using the
bins as handles can damage or break
them.
2
Move to the front of the printer.
3
Align the finisher with the
printer, as shown in the illustra-
tion to the left.
4
Orient the guide rail so the two
small labels are facing up.
One label is an illustration of a fin-
isher with extra output bins (your
finisher looks different), and the
other is an illustration of a printer.
Use the labels as a guide as you
continue with the following steps.
Finisher label
Printer label
To Next Page
Loading...
