117
Set up the optional finisher
1
Separate the finisher from the
printer.
2
Locate the four wing bolts
under the finisher’s base ledge
on the side that faces the
printer.
3
Turn the wing bolts counter-
clockwise to loosen them.
4
Turn the knobs on the base
ledge to adjust the finisher’s
height.
Turn the knobs clockwise to raise
the finisher. Turn the knobs coun-
terclockwise to lower it.
5
When the transport unit is level,
tighten the wing bolts you loos-
ened in step 3.
6
Push the finisher against the
printer.
To Next Page
Loading...
