140
Attach cables
To attach a cable to your printer:
1
Make sure the printer and the computer (or other devices
you plan to attach) are turned off and the power cords are
unplugged.
2
At the back of the printer, locate the parallel, serial, or net-
work cable connector.
One parallel connector is standard on all printer models. The
Optra W810n and Optra W810dn models also have a standard
Ethernet connector attached to the MarkNet print server
installed in the printer. You may have other cable connectors
available on your printer if you installed other print servers or
interface cards.
3
Connect the appropriate cable or cables.
Connect only one network cable to each MarkNet print server
installed in your printer, even if the print server has more than
one network port.
Note:
If you attach a USB
cable to a parallel/USB interface
card you’ve installed in your
printer, you must use the
Windows 98 operating system
and a Windows 98-compatible
driver to send print jobs to the
USB port.
4
Plug one end of the power cord into the socket at the back
of the printer and the other end into a properly grounded
electrical outlet.
Rear view
Parallel
connector
Network
connector
To Next Page
Loading...
