158
Set up network addresses
5
Print a new network setup page to verify the parameters
are set correctly.
See page 155 for instructions on printing the setup page.
Static ARP and telnet
You can use this method from any Windows, OS/2, or UNIX worksta-
tion. You need to know the physical address of the print server.
Note:
The workstation and
the printer must be on the same
subnet.
1
Find the physical address (UAA) of the print server (for
example, 00200022012F) on the network setup page.
— If you have an Ethernet network, use the number in the right
column (canonical).
— If you have a Token-Ring network, use the number in the left
column (MSB).
2
Set the IP address in your workstation ARP table. At a
command prompt, type a command similar to the follow-
ing, inserting the IP address you want to assign and the
UAA:
arp -s 192.168.236.24 00-20-00-22-01-2F
3
Set the IP address, netmask, and gateway in the print
server. To do this, telnet to port 9000 on the MarkNet print
server by typing a command similar to the following:
telnet 192.168.236.24 9000
4
Verify that the print server is up and running on the
network.
ping 192.168.236.24
To Next Page
Loading...
