82
Set up the optional mailbox
Warning!
Be sure to use both hands
to hold the transport unit while you posi-
tion it on the printer.
3
Position the transport unit on
top of the support shelf.
4
Open the transport unit cover.
5
Lower the metal shaft on the
bottom of the transport unit
into the two metal brackets on
the mailbox, as shown.
Make sure the thumbscrew and
gear on the ends of the shaft rest
outside the metal brackets.
Loosen the thumbscrew, if neces-
sary, to make installation easier.
6
Tighten the thumbscrew to
secure the transport unit to the
mailbox.
Gear
Thumb-
screw
To Next Page
Loading...
