The scan is complete when a message appears on the printer control panel indicating that the file you scanned has
been saved.
Scanning to a network computer
1 Load the original document.
2 From the home screen, touch Scan > Computer.
3 Touch the name of the destination computer.
Notes:
• Make sure the scan software is installed on the destination computer.
• Make sure the printer can communicate with the destination computer.
• You may be prompted to enter a PIN if the computer requires it.
• To assign a computer name and a PIN to the computer, see the Help for the printer software associated with
your operating system.
4 Select the output file type you want to create and other scan options. If necessary, touch Accept each time you
make a selection.
5 Press .
The scan is complete when a message appears on the printer control panel indicating that the file you scanned has
been saved.
Scanning a two‑sided document using the ADF
Depending on your printer model, the ADF can scan duplex (two-sided) pages in a single pass.
1 Load an original document faceup into the ADF.
2 Adjust the paper guides.
3 From the home screen, touch Scan.
4 Follow the instructions on the display, and then set the other scan options. If necessary, touch Accept each time
you make a selection.
Note: From the Sides menu in Scan Options, make sure you select 2‑Sided, and then touch Accept.
5 Press .
6 Follow the instructions on the display.
The scan is complete when a message appears on the printer control panel indicating that the file you scanned has
been saved.
Scanning to a flash drive or memory card
Before you begin, make sure your flash drive or memory card is not write‑protected.
1 Load the original document.
2 From the home screen, touch Scan > Memory Device.
Scanning
62
To Next Page
Loading...
