10 Press .
11 During the initial setup of your printer, you were prompted to enter the date and time. If you have not entered
this information:
a Press twice.
b Press or repeatedly until Tools appears.
c Press .
d Press or repeatedly until Device Setup appears.
e Press .
f Press or repeatedly until Date/Time appears.
g Press .
h Enter the date using the keypad.
i Press .
j Enter the time using the keypad.
k Press .
l If the hour you entered is 12 or less, press or repeatedly until AM, PM, or 24hr appears.
m Press to save the setting.
Related topics:
• “Using the control panel” on page 90
Blocking unwanted changes to fax settings
This feature blocks network users from changing fax settings.
1 From the control panel, press Fax Mode.
2 Press .
3 Press or repeatedly until Tools appears.
4 Press .
5 Press or repeatedly until Device Setup appears.
6 Press .
7 Press or until Host Fax Settings appears.
8 Press .
9 Press or until Block appears.
10 Press to save this setting.
Related topics:
• “Blocking junk faxes” on page 66
• “Using the control panel” on page 90
Faxing
65
To Next Page
Loading...
