57AS/400 and iSeries Installation Setup: Task 2 - Configuring a Print Server
IMPORTANT: The SCS/TNe Emulation can only
receive jobs through a single printer server.
Moving the selected print server or inserting a
new print server may cause a loss of SCS/TNe
print capability.
B. Configuring the Print Server
To enable SCS printing, several print server settings may need to be
changed. You can make these changes from the printer operator
panel.
1 Set NPA Mode to Auto. Select Menus > Network/Ports.
Select the print server to be used for SCS printing, for
example Standard Network, Network 1, or Network 2. Locate
NPA Mode and scroll to the Auto setting. Touch Submit to
save. This setting will ensure that the printer’s LAN
connection will detect the Card.
2 Set the Network Job Timeout. This timeout is used by all
print servers. Select Menus > Settings > General Settings>
Timeouts > Network Job Timeout. Scroll down to 0. Touch
Submit to save.
Option Value Description
Network
Job
Timeout
"0" This is the recommended setting and corre-
sponds to "disabled". Other settings may cause
communication problems. A setting of "0" allows
the host SNA server, or SCS/TNe emulation
timeout values to control when print jobs from
another protocol, interface, server, or host can be
started.
To Next Page
Loading...
