72
1-3. Adjustable components (seats, mirrors, steering wheel)
n Operating the driving position memory after turning the “ENGINE START
STOP” switch off
Memorized positions (except for the steering wheel position) can be activated up
to 180 seconds after the driver’s door is opened and another 60 seconds after it is
closed again, even after turning the “ENGINE START STOP” switch off.
n Canceling the linked door unlock operation
Turn the “ENGINE START STOP” switch to IGNITION ON mode and
close the driver's door.
While pressing the “SET” button, press the driver’s door lock switches
(either lock or unlock) until the signal beeps.
n Stopping seat position operation part-way through
Perform any of the following operations:
l Press the “SET” button.
l Press button “1”, “2” or “3”.
l Adjust the seat using the switches (only cancels seat position recall).
l Adjust the steering wheel using the tilt and telescopic steering control switch
(only cancels steering wheel position recall).
n Correct seat position
When the seat is in the most forward or most backward position, and the seat is
being moved in those directions, the system may not correctly recognize the cur-
rent position and the memorized position will not be correctly recalled.
n When the power easy access system (→P. 63) is activated
If a seat position is memorized, the driver seat will move back the set distance
(→P. 621) from that memorized position.
CAUTION
n Seat adjustment caution
Take care during seat adjustment so that the seat does not strike the rear passenger
or squeeze your body against the steering wheel.
STEP 1
STEP 2
To Next Page
Loading...
