163
2-1. Driving procedures
2
When driving
Turn signal lever
n Turn signals can be operated when
The “ENGINE START STOP” switch is in IGNITION ON mode.
n If the indicators flash faster than usual
Check that a light bulb in the front or rear turn signal lights has not burned out.
The turn signal lever can be used to show the following intention of the
driver:
Right turn
Left turn
Lane change to the right
(push and hold the lever part-
way)
The right hand signals will flash
until you release the lever.
Lane change to the left (push
and hold the lever partway)
The left hand signals will flash
until you release the lever.
To Next Page
Loading...
