415
3-7. Other interior features
3
Interior features
n Routing accessory device cables
n The power outlets can be used when
12 V
T
he “ENGINE START STOP” switch is in ACCESSORY or IGNITION ON mode.
120 VAC
The “ENGINE START STOP” switch is in IGNITION ON mode.
NOTICE
n To avoid damaging the power outlets
Close the power outlet lid when the power outlet is not in use.
Foreign objects or liquids that enter the power outlet may cause a short circuit.
n To prevent the fuse from being blown
12 V: Do not use an accessory that uses more than 12 V 10 A.
120 VAC: Do not use a 120 VAC appliance that requires more than 100 W.
If a 120 VAC appliance that consumes more than 100 W is used, the protection
circuit will cut the power supply.
n To prevent battery discharge
Do not use the
power outlets longer than necessary when the engine is not running.
n Appliances that may not operate properly (120 VAC)
The f
ollowing 120 VAC appliances may not operate properly even if their power
consumption is under 100 W:
l Appliances with high initial peak wattage
l Measuring devices that process precise data
l Other appliances that require an extremely stable power supply
When the cover is slide open, accessory
device cables can be pulled through the
opening.