427
3-7. Other interior features
3
Interior features
Press and hold one of the
HomeLink
®
buttons and the trans-
mitter button. When the
HomeLink
®
indicator light
changes from a slow to a rapid
flash, you can release both buttons.
If the HomeLink
®
indicator light
comes on but does not flash, or
flashes rapidly for 2 seconds and
remains lit, the HomeLink
®
button
is already programmed. Use the
other buttons or follow the “Repro-
gramming a HomeLink
®
button”
instructions. (→P. 429)
Test the HomeLink
®
operation by
pressing the newly programmed
button.
If a HomeLink
®
button has been
programmed for a garage door,
check to see if the garage door
opens and closes. If the garage
door does not operate, see if your
remote control transmitter is of the
rolling code type. Press and hold
the programmed HomeLink
®
but-
ton. The remote control transmitter
is of the rolling code type if the
HomeLink
®
indicator light flashes
rapidly for 2 seconds and then
remains lit. If your transmitter is of
the rolling code type, proceed to
the heading “Programming a roll-
ing code system”.
Repeat the steps above to program another device for each of
the remaining HomeLink
®
buttons.
STEP 2
STEP 3
STEP 4
To Next Page
Loading...
