255
4-5. Using the driving support systems
LS500h_OM_OM50F42U_(U)
4
Driving
increased or decreased as follows:
For the U.S. mainland, Hawaii
Fine adjustment: By 1 mph (1.6 km/h)
*1
or 1
km/h (0.6mph)
*2
each time the switch is
pressed
Large adjustment: Increases or decreases
in 1mph (1.6 km/h)
*1
or 1 km/h (0.6 mph)
*2
increments for as long as the switch is held
For Canada, Guam and Puerto Rico
Fine adjustment: By 1 mph (1.6 km/h)
*1
or 1
km/h (0.6mph)
*2
each time the switch is
pressed
Large adjustment: Increases or decreases
in 5 mph (8 km/h)
*1
or 5 km/h (3.1 mph)
*2
increments for as long as the switch is held
In the constant speed control mode
(→P.257), the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 mph (1.6 km/h)
*1
or 1
km/h (0.6 mph)
*2
each time the switch is
pressed
Large adjustment: The speed will continue
to change while the switch is held.
*1
: When the set speed is shown in “MPH”
*2
: When the set speed is shown in “km/h”
Pressing the switch changes the vehi-
cle-to-vehicle distance as follows:
1 Long
2 Medium
3 Short
The vehicle-to-vehicle distance is set auto-
matically to long mode when the power
switch is turned ON mode.
If a vehicle is running ahead of you, the pre-
ceding vehicle mark will also be dis-
played.
Select a distance from the table below.
Note that the distances shown corre-
spond to a vehicle speed of 50 mph
(80 km/h). Vehicle-to-vehicle distance
increases/decreases in accordance
with vehicle speed. When the vehicle is
stopped by system control, the vehicle
stops at a certain vehicle-to-vehicle
distance depending on the situation.
Changing the vehicle-to-vehicle
distance (vehicle-to-vehicle dis-
tance control mode)
Vehicle-to-vehicle distance set-
tings (vehicle-to-vehicle dis-
tance control mode)
Distance
options
Vehicle-to-vehicle dis-
tance
Long
Approximately 160 ft. (50
m)
A
To Next Page
Loading...
