354
5-6. Using the other interior features
LS500h_OM_OM50F42U_(U)
■ The power outlet can be used when
● 12 V
The power switch is in ACCESSORY or
ON mode.
● 120 VAC
The power switch is in ON mode.
1 To set the visor in the forward posi-
tion, flip it down.
2 To set the visor in the side position,
flip down, unhook, and swing it to
the side.
3 To use the side extender, place the
visor in the side position, then slide
it backward.
Front
Slide the cover to open.
The vanity light turns on.
■ To avoid damaging the power outlet
Close the power outlet lid when the
power outlet is not in use.
Foreign objects or liquids that enter the
power outlet may cause a short circuit.
■ To prevent the fuse from being blown
● 12 V
Do not use an accessory that uses more
than 12 V 10 A.
● 120 VAC
Do not use a 120 VAC appliance that
requires more than 100 W. If a 120 VAC
appliance that consumes more than 100
W is used, the protection circuit will cut
the power supply.
■ To prevent 12-volt battery discharge
Do not use the power outlet longer than
necessary when the hybrid system is off.
■ Appliances that may not operate
properly (120 VAC)
The following 120 VAC appliances may
not operate properly even if their power
consumption is under 100 W.
● Appliances with high initial peak watt-
age
● Measuring devices that process pre-
cise data
● Other appliances that require an
extremely stable power supply
Sun visors
Vanity mirrors