1000i Series IP Phone (SMB)
User Guide Issue 1.0
20
2.2 Using the Speakerphone
Activate the iPECS Speakerphone at any time (except for Paging) in place of lifting the handset to receive or
place calls.
Additionally, you may switch between the handset and Speakerphone during a call. By keeping the handset
Off-hook, the Group Listen feature is activated, which provides incoming audio over the speaker with outgoing
audio from the handset. This permits a local ‘group’ to listen to both sides of the conversation without
interfering with the conversation.
While in a conversation using the Speakerphone, Mute the microphone using the MUTE button. When Mute is
active, the MUTE button LED will be illuminated. To turn off Mute, press the MUTE button again.
With Auto Speaker Select, activating or accessing a feature, or placing a call by pressing a flexible button will
activate the Speakerphone automatically.
When using a Headset, the SPEAKER button controls the ON/OFF-hook state for the phone.
To use the Speakerphone to answer or place a call
✓ Press the SPEAKER button, the phone goes off-hook and sends audio to the speaker and from the
microphone.
To control the volume of the Speakerphone or handset
✓ During a call, press the VOLUME + or – button.
To mute the microphone: (Speakerphone or handset)
✓ During a call, press the MUTE button.
To turn off Mute (turn the microphone ON)
✓ Press the MUTE button. Mute LED will be turn off.
To activate Group Listen while on an active handset call
1) Press the SPEAKER button.
2) Replace the handset on the Station.
To Next Page
Loading...
