1000i Series IP Phone (SMB)
User Guide Issue 1.0
22
3.3 Using Answering Machine Emulation (AME)
When your phone is allowed AME, your calls are connected to your voice mail directly, and, like a normal
Answering Machine, the caller’s voice is played over your speaker as it is recorded in the mailbox. Thus, you
can screen the call before answering. There are two methods of notification and call screening provided, Ring
or Speaker mode.
Ring mode — In the Ring mode, the AME flexible button will flash to notify you of a call. You may
press the flexible button to hear the caller as the voice message is recorded.
Speaker mode — In the Speaker mode, the caller’s voice is broadcast over the speaker of your iPECS
Phone automatically.
Your iPECS Phone must be assigned with an AME Flex button for proper operation. AME is supported only on
iPECS Phones.
To screen a call in Ring mode:
✓ Press the flashing AME button, the caller’s voice is broadcast over the station speaker and stored in the
voice mailbox. In the Speaker mode, broadcast is automatic.
To stop the voice broadcast and leave the caller in Voice Mail:
✓ Press the illuminated Speaker button.
To talk with the caller and record the conversation in Voice Mail:
✓ Press the MUTE button.
To answer the call and cancel the voice message recording:
✓ Press the illuminated AME button, the caller is connected, and the Voice Mail disconnected.
3.4 Differential Ring Signals
When multiple phones in a small area ring, it can be difficult to tell which are ringing. The iPECS Phone has 16
Ring Tones available for differentiating one phone’s ringing from another. This feature can also be used to
differentiate internal and external callers. Of the 16 tones, 4 are downloaded from the system and the
remaining 12 are stored in the phone’s memory.
After downloading the tone from the system memory, it can be selected as the Differential Ring Tone.
To download a Ring Tone from the System:
1) Press the Transfer (PGM) button and Dial 1 for Ring Tones.
2) Dial 5 for Ring Tone download.
3) Dial the phone’s memory location to receive the tone (5-8).
4) Dial 0-9 for the desired tone number; the selected tone is heard.
5) Press the HOLD(SAVE) button to download the tone to your phone.
To select a Ring Tone from phone memory:
1) Press the Transfer (PGM) button and Dial 1 for Ring Tones.
2) Dial 1 for internal call ring or 2 for External call ring.
3) Dial 1-16 for the desired tone; the selected tone is heard.
4) Press the HOLD(SAVE) button to complete the selection.
To Next Page
Loading...
