25
PROGRAMMING MODE
Algorithm flow chart shows how to control programming mode.
Before program set, check the structure of programming mode.
The method of entering set up mode.
1) Push the 90°C (194°F) & 60°C (140°F) button at the same time.
2) Push the 75°C (167°F) button 3 times.
3) Push the Start button.
4) Display will show “ ”.
is to set price value, time value, and vend type etc.
consists of line test, reset, free cycle, and kill cycle.
OPL type
Structure of Programming mode
NOTE
• Do not use , .
• It is used only in inspecting the machine.
• After EEPT, reset your country. (Default country is EUK)
• Price setting varies by country.
• Set your country from mode. (Refer
How to enter the
)
To Next Page
Loading...
Need help?
General
