26
PROGRAMMING MODE - SETUP MODE
Setup Mode : (display)
You can change washer vend price, cycle time, and cycle parameters, etc.
Entering set up mode
- Coin type – Turn on/off toggle switch.
- Coin/OPL type
1) Push the 90°C (194°F) & 60°C (140°F) button at the same time.
2) Push the 75°C (167°F) button 3 times.
3) Push the Start button.
- Then, the washer displays .
1. How to change regular price.
Entering set up
mode.
You will see LqC1
Button Display
Press the
90°C (194°F)
button.
Press the
75°C (167°F)
or the
60°C (140°F)
button until
appears in the display.
Press the
Start
button.
Press the
Start
button.
Display previous regular price.
Press
75°C (167°F)(+)
or
60°C (140°F)(-)
button to set
the regular price.
(The vend price can be set from 0~10,00 in 0,1
increments.)
Press the
Start
button.
The machine sets up the regular price, then advances
to the next process automatically.
If this function is restricted originally in program,
You can move to the next step by pushing the 60°C
(140°F) button.
1. Continue to set up the next price.
2. Stop the change of setup value and go back to ready
mode.
• Coin type - Turn on/off toggle switch.
• Card type - Pull the service card.
• All types - Push the 90°C (194°F) button twice.
NOTE
• Price setting varies by country
• Set your country from mode. (Refer
How to enter the
)
• After EEPT, reset your country. (Default country is EUK)
• This function is not applied for opl type.