Phone Basics 10
Turn Your Phone On
■ Press and hold the Power/Lock Button .
Once your phone is on, it may display “Searching for Service.” When your phone finds a signal,
it enters standby mode – the phone„s idle state. At this point, you are ready to begin making and
receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a Power Save feature is
automatically activated. When a signal is found, your phone automatically returns to standby
mode.
In Power Save mode, your phone searches for a signal periodically without your intervention.
You can also initiate a search for Sprint service by pressing any key (when your phone is turned
on).
Tip: The Power Save feature conserves your battery power when you are in an area where
there is no signal.
Turn Your Phone Off
1. Press and hold the Power/Lock Button for two seconds until you see the Phone
options on the display screen.
2. Tap Power off and then tap OK to power off the phone.
Your screen remains blank while your phone is off (unless the battery is charging).
Wake Up the Screen
If you don„t use the phone for a while, the screen and backlight will shut off to conserve battery
power.
1. Press the Power/Lock Button . Your lock screen will appear. See Lock Screen.
2. Swipe the screen to any direction to unlock it. The last screen you were working on
opens. (This is the default lock screen.)
Turn Your Screen On and Off
You can set the phone to turn the screen on or off by quickly double-tapping the screen.
Turn the Screen On
1. Double-tap the center of the Lock screen to turn the screen on.
2. Unlock the screen.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
