23
3. Use 4 (ON) or 6 (OFF) number buttons to select
Alarm Output Mode then press ENTER.
• ON: If alarm input comes in, the camera
sends output signals.
• OFF: The camera does not send an output
signal.
4. Enter a [Alarm Index] number (1 to 4) then press
ENTER.
5. Enter a [Duration] (0 to 255) then press ENTER.
Sends the output signals for the selected dura-
tion. (0 (Manual mode); the camera sends output
signals continuously.)
Alarm output setting is finished and the setting is
memorized to the camera’s memory.
6. Repeat steps 3 to 5 to set additional Alarm Output.
Auto Pan Setup and Activation
You will set up and activate the auto pan function.
The camera can pan among the points you will set.
Note:
Refer to the operating instructions of camera for
details on the auto pan function.
To set the points of auto pan
1. Select the [AUTO PANNING] icon and press
ENTER. The sub menu will appear.
2. Select [Set Auto Panning] option then press
ENTER. The sub menu will appear.
3. By moving the joystick, move the camera to a
point you want.
4. Enter a [Speed] (1 to 127) to move to the preset
position. Then press ENTER.
5. Enter a [Park Time] (holding time) at the preset
position (1 to 255). Then press ENTER.
The setting is finished and the setting is memo-
rized in the camera’s memory.
6. Repeat the steps 3 to 5 to add additional position.
Note:
When the maximum position is reached, it goes
automatically to upper level menu. Use the CLR but-
ton to quit this menu before the maximum position is
reached. Please refer to the camera's manual for the
number of available auto panning position.
To Next Page
Loading...
Need help?
General
