25
5. If you finish to record, press ENTER or CLR.
The pattern is memorized in the camera’s mem-
ory.
6. Repeat the steps 2 to 5 to add additional position.
Note:
The available total time of pattern differs depending
on camera’s operation.
Pattern Play
You can activate the pattern play function for the
selected camera.
1. Select the [PATTERN] icon and press ENTER.
The sub menu will appear.
2. Select [Play Pattern] option then press ENTER.
The sub menu will appear.
3. Use number buttons to enter the memorized pat-
tern index number then press ENTER.
The camera plays the pattern.
4. Move the joystick to stop playing.
Privacy Setup
This setting is used for masking unwanted zones,
hiding them from display on the monitor screen.
Up to 8 zones can be registered. Submenus are
provided for zone number selection and parameter
setting.
To register a new privacy zone
1. Select the [PRIVACY ZONE] icon and press
ENTER.
The sub menu will appear.
2. Select [Set Zone Area] option then press ENTER.
The sub menu will appear.
3. Use number buttons to select the zone index num-
ber then press ENTER to confirm.
The zone frame appears on the center of monitor.
4. Adjust the pan, tilt, and zoom position so that the
desired position comes into the zone frame with
the joystick.
5. Press ENTER. The privacy zone setting has been
completed.
6.
Repeat the steps 2 to 5 to add additional position.
To Next Page
Loading...
Need help?
General
