56
ACCESSORIES INSTALLATION
ENGLISH
Accessories supported by 3rd party Companies
Item Purpose Specification
Thermostat To control by air temperature
Heating-Only type (230 V AC)
Cooling/Heating type (230 V AC with
Mode selection switch)
3
rd
Party Controller
To connect external controller using
modbus protocol
3way valve and actuator
(A) : To control water flow for hot
water heating or floor heating / To
control water flow when installing
3rd party boiler
(B) : To control close/open mode of
solar circuit
3 wire, SPDT (Single Pole Double Throw)
type, 230 V AC
External Pump
To retain sufficient capacity using
additional pump
Smart Grid
To control operation mode depending
on input signal from provider
To Next Page
Loading...
Need help?
General