113
ENGLISH
112
ENERGY
● Press the remote controller screen’s ‘Energy’ button.
- It moves to the Energy screen.
Alarm Popup
This function allows you to set up a popup notice message for the Power Consumption and Op-
eration Time Restriction feature. It will be displayed on the remote controller once a percentage
threshold is reached (i.e., 80%, 90% etc. of power consumption or time target).
● In the Energy Saving screen, press ‘Settings’ button.
- It moves to the Energy setting screen.
● In the Energy setting screen, Press ‘Alarm Popup’ button.
- It moves to the Alarm Popup setting screen.
ENERGY
● In the Time Limit Control Setting screen, press the Enable button to begin setting a time limit.
● Press ‘▲’, ‘▼’ button to set the operation hours.
● Press the Done button to save the set time value.
- If you exit without pressing the Done button, your changes will not be applied.
h When the operation stops, the calculated time value will reset to its initial value.
Example: If the Time Limit Control is set to operate for 1 hour, but the unit is prematurely
stopped after 25 minutes, the time will reset back to the full 1 hour control limit. The
next time the unit begins operation, it will again start at the 1 hour limit mark to
countdown.
To Next Page
Loading...
