Liebert GXT4 - 2 Installation; Unpacking and Inspection; Whats Included; Preparation for Installation

Installation
Liebert
®
GXT4
™
10
2.0 INSTALLATION
2.1 Unpacking and Inspection
Unpack the UPS and conduct the following checks:
• Inspect the UPS for shipping damage. If any shipping damage is found, report it to the carrier and
your local dealer or Emerson
®
representative immediately.
• Check the accessories against the delivery list. If there is any discrepancy, contact your local
dealer or your Emerson representative immediately.
2.2 What’s Included
• Terminal Block Communication Terminals
• Compact Disk with:
• Liebert MultiLink
®
Shutdown Software
• Configuration Program
• User Manual
• USB Cable—one, 1.2m (3.9 ft.) long
• RS-232 Cable—one, 2m (6-1/2 ft) long
• Cable Strain Relief—two pieces
• Rack mounting hardware, including screws, handles and mounting rail kit (not included with “E”
models)
• Plastic tower stand sets—two (four pieces)
• Warnings, Safety Instructions booklet and WEEE recycling sheet (ISO 14001 compliance)
With 700VA - 1500VA Units:
• 10A IEC C13 C14 Output Cable—two, 2m (6-1/2 ft.) long
• CEE 7/7 (Schuko) to IEC C13 input cord—one, 2.5m (8-1/2 ft.) long (not included with “E” models)
• BS 1363 (UK) to IEC C13 input cord—one, 2.5m (8-1/2 ft.) long (not included with E models)
• Australian type A to SAA input cord—one (except “E” models)
With 2000VA - 3000VA Units:
• 10A IEC C13 C14 Output Cable—three, 2m (6-1/2 ft.) long
• CEE 7/7 (Schuko) to IEC C20 Input Cable—one, 2.5m (8-1/5 ft.) long (not included with “E”
models)
• BS1363 (UK) to IEC C20 Input Cable—one, 2.5m (8-1/5 ft.) long (not included with “E” models)
• Australian type A to SAA input cord—one (not included with “E” models)
2.3 Preparation for Installation
2.3.1 Installation Environment
• Install the UPS indoors in a controlled environment where it cannot be accidentally turned Off.
The installation environment should meet the specifications in 9.0 - Specifications.
• Place the UPS in an area where airflow around the unit is unrestricted and away from water,
flammable liquids, gases, corrosives and conductive contaminants. Avoid direct sunlight.
NOTE
The GXT4 External Battery Cabinet shipping package includes one battery cabinet, two spacers
for tower configuration and one DC power cable and rack mounting hardware, including
screws, handles and mounting rail kit (not included with “E”) models.
NOTE
Operating the Liebert GXT4 in temperatures above 25°C (77°F) reduces battery life.