Lighthouse ApexZ Series - Dhcp

Lighthouse Worldwide Solutions ApexZ Operators Manual
248083466-1 R3 36
DHCP (Dynamic Host Configuration Protocol)
When DHCP is enabled the IP Address, Subnet and Gateway will be dynamically assigned from the HOST
network connection and user editing will be locked. In order to enable DHCP you must disable the
Ethernet connection first.
Enable DHCP
Disable the Ethernet connection
to allow DHCP to be enabled.
Press the enable DHCP button
to Enable DHCP detection.
The IP Address, Subnet and Gateway
will be automatically assigned.
Enable Ethernet to complete the
DHCP connection.
Ethernet and DHCP Enabled
2
1
Ethernet Disabled DHCP Assigned
3
Note: When Ethernet is disabled
and DHCP is enabled the IP
address, subnet and gateway will
be displayed and locked. No user
input is required.