Lightware DVI-HDCP-TPS-TX210 - Hdmi-Tps-Tx226

3. Installation  

HDMI-TPS-TX226
DIFFERENCE:  


▪ 
▪ 
▪ 
             

A
Using local PSU
.
B


you will need 

C
Using Remote Power (12V over TPS) from HDMI-TPS-RX96

Important Notes when Remote Powering the HDMI-TPS-TX226
Cabling
▪ prevent ground potential difference.
▪ The maximum transmission distance may be limited. Maximum recommended cable length is 30m.
▪ The CATx cable must not be cut or crimped when it is connected
Ground loop
▪ 
▪ The CATx cable should run on a similar path as the power lines and safety ground wire

▪ The connected source and sink devices at the two endpoints should have the same Earth potential

▪ 
cause audible noise
Di-Box (audio balun) on the audio input, or to use the balanced audio input




