7. Firmware Upgrade DVI-OPT-220-Pro series – User's Manual 30
the device is switched to
Bootload-mode and the display
shows Firmware upgrade in progress…
(if the extender is switched off and on again, the display will be empty).
ATTENTION! The extender cannot be switched back manually
to normal operation mode, it will be done automatically after
If you wish to connect, click YES to establish connection with the
extender. It will take 10-15 seconds to get all information.
INFO: The bootloader application will restart the extender when it
establishes the connection. All connected DVI source and monitors
will act as if the extender was powered down.
Step 4.
After the connection is made, the device properties, and the installed
controller modules are displayed. Select the controller type that needs
Step 5.
Click the corresponding cell in the Browse New Firmware column.
Step 6.
Click UPGRADE SELECTED FIRMWARES button on the left side. A
After clicking the YES button the selected controller is being
the bootloader software faster by only checking the checksum of the
was correct.
INFO: The reprogramming can take between 3-8 minutes.
the programming is done, so the progress bar runs up twice.
Done! message will appear in
the bottom left corner. The application closes the connection, and the
extender restarts.
Firmware upgrade
in progress...
Step 7. Done!
If the upgrade was successful, the following window pops up:
Now you can close the application, or you can select another device
to upgrade.
After closing the bootloader application, switch the upgraded device
off and then on. Now the device is ready to be used with the new
will be set as emulated EDID on the input.
To Next Page
Loading...
Need help?
General