UCX series – User's Manual 110
Identifying the Device
Command and Response #identifyme
ç
æ
Example
ç
æ
Toggling the Dark Mode Setting
#darkmode
Command and Response
ç <mode_state>
æ <mode_state>
Parameters
If the <mode_state> parameter is true (or 1), the Dark mode function is enabled, if the parameter is false (or 0),
the function is disabled.
Example
ç
æ
Setting the Delay of the Dark Mode Setting
The Dark mode can be enabled rightaway, or after a certain time. Thus, the mode is enabled, if no buttons
function of the button itself. The delay time can be set by this command.
Command and Response
ç <delay_time>
æ <delay_time>
Parameters
The <delay_time> parameter means seconds, and the default value is 60. If set to 0, no delay is applied, and
the Dark mode can be enabled immediately by the DarkModeEnable property. This delay has an affect to the
wakeFromDarkMode method as well.
Example
ç
æ
Video Port Settings - General
Switch Video Input
Command and Response
ç <in>:<out>)
æ mO·
Example
ç
æ
INFO:
output.
ATTENTION!
of them can be selected to any output.
not be switched to I1 or I5. In this case the switch command returns error message.
Example
ç
æ
ç
æ
ç
æ
Switch an Input to All Outputs
Command and Response
ç <input>)
æ mO·/V1/MEDIA/VIDEO/XP:switchAll=
Example
ç
æ
To Next Page
Loading...
Need help?
General
