UCX series – User's Manual 56
Autoselect
Autoselect feature makes possible switching input to the output without human intervention. The crosspoint
state changes the based on the active input signals.
Three operation policy can be set:#autoselect # videoautoselect
Disable autoselect: crosspoint state change happens manually.
First detect: selected input port is kept connected to the output as long as it has an active signal.
Last detect mode: always the last attached input is selected to transmit.
Individual input settings: always the highest priority active input is selected to transmit (1- highest priority, 100-
lowest priority).
Pay attention for the following settings for the proper operation of the Autoselect function:
–
– Be sure that all inputs are enabled with the green tick on the right side;
– Always click on the Apply autoselect settings button after the changes to launch the new settings.
See more details about the feature in The Autoselect Feature section.
Embedded Audio Input
Port properties window of the audio input
Available settings
Port name
The name of a port can be changed by typing the new name and clicking on the Set button. The following
dot (.). Max length: 63 characters.
Lock #lock #unlock
The port can be locked to the currently connected output ports by putting the tick. If the port is locked, the
crosspoint state of this port cannot be changed.
Mute #mute #unmute
transmitted from the input port.
ATTENTION!
one of them can be selected to any output.
of the I1 is not available because of the video crosspoint limitation. For more details about it see the port
diagram in Audio Interface section.
To Next Page
Loading...
Need help?
General
