UCX series – User's Manual 67
System
System tab in Settings menu
The following functions are available under System tab:
▪ Support package
▪ Load factory defaults - recalling factory defaults settings and values. All factory default settings are
listed in the Factory Default Settings section.
▪ Reboot - rebooting the system.
▪ Set time - (internal clock) of the switcher which is used for logging events.
▪ Pressing Sync with Computer button is a quick and easy way to set the time. #factory #log
#systemlog #reboot #restart
ATTENTION! Please ensure proper UCX time and date setting in UCX because it affects the self-signed
Script management
DIFFERENCE:
Put a tick to enable the Run script. It means, that the script runs until the uploading another script or disable
this function.
Click Upload File
DIFFERENCE:
and upload to another device.
ATTENTION!
version is installed on the devices.
Click on the Download Clone File button to save the setting to the computer.
Step 1. Choose the desired network setting from the drop down menu:
▪ Keep unchanged.
▪
▪ Set to DHCP mode.
▪ Set to custom non-DHCP mode (in this case additional settings required: IP Address, Subnet Mask,
Gateway Address).
INFO:
and the hostname property. Network service settings (enable http(s) ports, authentication etc.) will be
always restored.
Step 2. Click on the Select le
Step 3. The clone process will start by clicking on Restore button.
To Next Page
Loading...
Need help?
General
