3. Installation UMX-TPS-TX100 series – User's Manual 34
Analog Stereo Audio (Jack)
The connector is used for receiving unbalanced analog audio signal. It is also known as (3.5 mm
Jack audio plug pin assignments
Audio Interface section.
Analog Stereo Audio (Phoenix)
5-pole Phoenix connector is used for balanced analog audio input in the UMX-TPS-
TX140 and UMX-TPS-TX140-Plus transmitters. Unbalanced audio signals can be
connected as well. See more details about the balanced and unbalanced input port
wiring in the section.
Analog audio connector and plug pin assignments
Compatible Plug Type
Phoenix
®
Audio Interface section.
Ethernet Connector (TPS and LAN Ports)
cable for connecting transmitters and receivers.
Ethernet
connector
TPS connector of UMX-TPS-
TX100 series transmitters
TPS connector of FP/WP-UMX-
TPS-TX100 series transmitters
Pin nr. Signal
1
2 Right
3 Ground
Pin nr. Signal
1
2
3 Ground
4 Right-
5 Right+
RJ45 LED States
Wiring of TPS and LAN Cables
standards.
Pin assignments of RJ45 connector types
Maximum CATx cable distances can be found in the Maximum Extension Distances
more information about TPS interface in the TPS Interface section.
Ethernet port
LED1, amber LED2, green
OFF no link 10 Mbps
Blinking activity
ON link is active 100 Mbps
Pin TIA/EIA T568A Wire color TIA/EIA T568B Wire color
white/greenwhite/orange3
white/green white/orange1
blue blue4
white/blue white/blue5
brown8 brown
white/brown7 white/brown
greenorange6
green orange2
To Next Page
Loading...
Need help?
General
