Page 174 of 192
Deep discharge protection
• The BA21 Li-Ion has a deep discharge protection to protect the battery life. The deep discharge protection is activated when the battery is discharged.
• Charge the battery to exit the deep discharge mode. Ensure that the battery is sufficiently charged before use.
If the battery is completely discharged, the charging will be started at a very small rate to protect the battery. In this case the yellow LED will be
flashing. If the battery does not stop flashing and start charging normally within 12 hours (LED ON), the battery is defect and must be disposed
according to disposal instructions.
If any and all of the lithium ion batteries built into LINAK products are found to be defective under warranty, LINAK will provide a new product to the
OEM. LINAK explicitly disclaims all other remedies. LINAK shall not in any event be liable under any circumstances for any special indirect punitive
incidental or consequential damages or losses arising from any incident related to the inherent risk of thermal runaway in the lithium ion cell and any
use of LINAK products. Moreover, LINAK explicitly disclaims lost profits, failure to realise expected savings, any claim against our customer by a third
party, or any other commercial or economic losses of any kind, even if LINAK has been advised of the possibility of such damages or losses.
Transportation
The lithium ion batteries must be packed and transported according to applicable regulations. Always ask your local transportation provider how to
handle the transportation of lithium ion batteries.
• If the clips are not engaged fully, the tab
will be sticking out as indicated.
• Insert the battery connection cable into the battery port in the control box.
• Ensure that it is fully connected.
• Reconnect any actuator cables or hand
control cables to the correct ports.
• Close the control box lid, ensuring that the
locking clips fully engage.
• Reconnect the mains cable to the control box,
ensuring that the locking clip engages.
• Turn on or reconnect the mains outlet.
Recommendations:
• Do not exceed the storage temperature as it will shorten the product lifetime and reduce performance.
• Allow the battery to settle to room temperature before use or charging.
• Do not exceed the duty cycle 1/19 as it will shorten the lifetime, reduce performance, and eventually activate over temperature protection.
• BA21 Li-Ion is neither intended for use in outdoor applications, pool environments nor other harsh environments.
• If the battery is completely discharged, then recharge the battery before storage.
• Only charge with applicable LINAK control boxes.
To Next Page
Loading...
Need help?
General
