Page 27 of 192
Warnings
• When using BAJL and JUMBO control boxes, loss of power might happen due to the battery deep discharge protection. This will only happen in
case of continuous battery use despite warnings. In this event, there may be no warning, and the application may not be able to move when
expected.
• In his risk analysis, the customer must take into consideration how to assure alternative means to make movement, for instance quick release or
manual lowering.
• The combination of CBJ1 or CBJ2 with BAJL might not be able to complete a full cycle after low battery warning.
• Do not open the battery housing as damaging the cell or circuitry may develop excessive heat.
• If product caution is not clearly visible at low light intensity, read the product label instructions symbol. A warning must be included in the
application manufacturer manual for the medical device.
• The application manufacturer must test the application and ensure that intentional and unintended operations do not exceed the battery
specification limits.
• Defective or damaged Li-Ion batteries are not allowed for transportation.
• For safety reasons, please adhere to the indicated charging and operation temperature.
• In case the battery is too hot, disconnect it, evacuate the room, and wait for 2 hours before taking further steps.
• Mounting instructions must be followed in order to avoid exposing batteries to water.
• Recharging of battery must take place every 6 months.
• Disposal of the battery takes place in accordance with local regulations.
Recommendations:
• Do not exceed the storage temperature as it will shorten the product life and performance.
• Allow the battery to settle to room temperature before use.
• Lithium ion batteries are not intended for use in outdoor applications and indoor pool environments.
• If the battery is completely discharged, then recharge the battery before storage.
• Always use correct LINAK
®
charger.
DO NOT:
• Heat or burn the batteries.
• Short circuit the batteries.
• Expose the batteries to high impact/excessive force.
• Crush or puncture the batteries.
• Use batteries with signs of damage or corrosion.
• Charge or store the batteries near combustible material.
• Expose the batteries to water or other liquids.
• Overcharge or fully discharge the batteries.
For detailed information on specific use of batteries, please see the product information in chapter 5.
Safety feature
Lithium ion batteries contain several mechanisms to protect themselves from being damaged due to excessive use.
In case of overheating, the device will activate a thermal protection. No power output will be available until the temperature is again within normal
operating range.
Overheating may occur by extensive use at high temperatures or when exceeding the duty cycle. (see product label)
Batteries
Lithium ion batteries
To Next Page
Loading...
Need help?
General
