Maintenance 5
Engine
¾ Check the indicator unit (4).
The
Oil display (5) (special equipment) in the
indicator unit must go out. The oil level will not
be displayed reliably in the indicator unit until
approx. 10 minutes after the oil is added.
NOTE
After changing the oil and the filter, carry out
an engine test run, checking the oil pressure
indicator and the tightness of the oil drain plug
and oil filter. For an accurate oil-level check,
especially after changing the oil filter, it is ne-
cessary to switch off the engine again and then
carry out an oil-level check after approx. one
minute.
Engine oil filter change
WARNING
When engine oil is hot there is a risk
of scalding!
Wear protective clothing
ENVIRONMENT NOTE
Take note of information about working mate-
rials.
¾ Open the bonnet.
Operating Instructions – 393 807 1001 EN – 08/2008 117
To Next Page
Loading...
