Maintenance 5
Chassis, bodywork and fittings
Check the seat belt for condition and
proper operation
NOTE
For safety reasons the conditi
on and proper
operation of the restraint sys
tem should be
inspected regularly (month
ly). Under extreme
operating conditions this c
heck is required
daily before taking the truc
k into operation.
d3921441
2
1
3
¾ Pull the belt (1) out fully and inspect for fray-
ing.
¾ Check the buckle (3) for correct operation
and the retractor for proper return of the belt.
¾ Check the trims for damage.
Check the automatic lock.
¾ Park the truck on level ground.
¾ Pull out the belt with a jerk.
The automatic lock should prevent the belt
from unrolling from the retractor (2).
¾ Slide the seat fully forward.
¾ Tilt the backrest fully forward
.
NOTE
When opening the bonnet, watch out for a
possibly installed rear windscreen.
d3921442
30˚
4
¾ Unlock the bonnet and open it wit
h the seat
(4) about 30°.
The automatic lock should prevent the belt
from unrolling from the retractor (2).
WARNING
Do not operate the lift truck with a defective seat
belt. The seat belt must be renewed after an ac-
cident. In the case of seat belts attached to the
operator’s seat, the seat and mounting of the seat
must also be inspected by qualified personnel. Nuts
and bolts should be checked regularly for tightness.
A wobbling of the seat can indicate loose bolts or
other faults. In case of non-observance, you will
put your health at risk and increase the risk of acci-
dents.
If malfunctions in the operation of the seat are de-
tected (eg springy seat), contact your authorised
dealer immediately to eliminate the cause.
Operating Instructions – 393 807 1001 EN – 08/2008 155
To Next Page
Loading...
