Linksys LAPAC1750PRO User Manual

Section 2: Viewing Access Point System Status
LAPAC1750PRO Access Point Software User Manual
11
WLAN Bytes
Transmitted
Total bytes transmitted by the AP on this radio interface.
WLAN Packets
Received
Dropped
Number of packets received by the AP on this radio
interface that were dropped.
WLAN Bytes
Received
Dropped
Number of bytes received by the AP on this radio interface
that were dropped.
WLAN Packets
Transmit
Dropped
Number of packets transmitted by the AP on this radio
interface that were dropped.
WLAN Bytes
Transmit
Dropped
Number of bytes transmitted by the AP on this radio
interface that were dropped.
Fragments
Received
Count of successfully received MPDU frames of type data
or management.
Fragments
Transmitted
Number of transmitted MPDU with an individual address
or an MPDU with a multicast address of type data or
management.
Multicast
Frames
Received
Count of MSDU frames received with the multicast bit set
in the destination MAC address.
Multicast
Frames
Transmitted
Count of successfully transmitted MSDU frames where the
multicast bit is set in the destination MAC address.
Duplicate
Frame Count
Number of times a frame is received and the Sequence
Control field indicates it is a duplicate.
Failed Transmit
Count
Number of times an MSDU is not transmitted successfully
due to transmit attempts exceeding either the short retry
limit or the long retry limit.
Transmit Retry
Count
Number of times an MSDU is successfully transmitted after
one or more retries.
Multiple Retry
Count
Number of times an MSDU is successfully transmitted after
more than one retry.
RTS Success
Count
Count of CTS frames received in response to an RTS frame.
RTS Failure
Count
Count of CTS frames not received in response to an RTS
frame.
ACK Failure
Count
Count of ACK frames not received when expected.
FCS Error Count Count of FCS errors detected in a received MPDU frame.
Transmitted
Frame Count
Count of each successfully transmitted MSDU.
WEP
Undecryptable
Count
Count of encrypted frames received where:
1. The key configuration of the transmitter indicates that
the frame should not have been encrypted.
2. The frame was discarded due to the receiving station
not implementing the privacy option.

Linksys LAPAC1750PRO Specifications

General

Modulation	-
VLAN support	Yes
Frequency band	2.4, 5 GHz
Number of users	- user(s)
Channels quantity	- channels
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3at, IEEE 802.3u
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum data transfer rate	1750 Mbit/s
Internal	No
Certification	FCC, CE, IC
Product color	White
Cable lock slot type	Kensington
Ethernet LAN (RJ-45) ports	2
Security algorithms	802.1x RADIUS, WEP, WPA, WPA2
Antenna gain level (max)	5.2 dBi
Input current	2 A
AC input voltage	12 V
Power consumption (typical)	24 W
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 35 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	238 mm
Width	247 mm
Height	43.3 mm
Weight	520 g