Linksys LAPAC1750PRO

90
Section 3: Configuring the Access Point
LAPAC1750PRO Access Point Software User Manual
Instance Configuration
You can create up to two Captive Portal instances; each CP instance is a defined
set of instance parameters. Instances can be associated with one or more VAPs.
Different instances can be configured to respond differently to users as they
attempt to access the associated VAP.
Click the Configuration > Captive Portal > Instance Configuration tab to access
the page.
Figure 48 shows the CP Instance Configuration page when the Create option is
selected from the Captive Portal Instances menu.
Figure 48: CP Instance Configuration - Create
Figure 49 on this page shows the CP Instance Configuration page when a CP
instance has been created and is selected from the Captive Portal Instances
menu. The fields available also change depending on the option selected from
the Verification menu. In Figure 49 on this page, the verification method is
RADIUS.
Figure 49: CP Instance Configuration
The following table describes the fields on the CP Instance Configuration
page. The fields that appear on the page depend on the option selected from
the Captive Portal Instances menu.