Linksys RE7000 User Manual

17
How to Access the Settings Interfa ce
To change or view range extender settings, rst connect to an extended network, e.g.,
MyWiFi_Ext. In a browser, go to http://extender.linksys.com and enter admin password.
Your range extender's default admin password is "admin". It is highly recommended that you
change this after WPS setup.
To change your admin pas sword , click the
Management
tab of the settings interface and enter a
new password under
Extender Access .
If you have not changed the range extender ’s default name, you can also access the settings
interface when connected to your main router .
Enter into a browser http://RE7000 -X XX (Window s) or http:/ /RE7000 -X XX.local or (Mac OS X
or iO S).
Note —XXX are the last 3 digits of your range extender’s MAC address. You can nd the MAC
address on the back of your RE 70 00. (You might have to unplug your range extender to see the

Linksys RE7000 Specifications

General

Type	Network repeater
Ethernet LAN	Yes
Ethernet LAN data rates	10, 100, 1000 Mbit/s
Maximum transfer distance	900 m
Ethernet LAN interface type	Gigabit Ethernet
Wi-Fi standards	802.11a, Wi-Fi 5 (802.11ac), 802.11b, 802.11g, Wi-Fi 4 (802.11n)
Cabling technology	10/100/1000Base-T(X)
Networking standards	IEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Wi-Fi data rate (max)	1900 Mbit/s
Ethernet LAN (RJ-45) ports	1

Weight and Dimensions

Depth	81 mm
Width	126 mm
Height	46 mm
Weight	255 g