91
Table of Contents
Linksys
STEP 4 Select an interface, and click Edit.
STEP 5 Select one of the following:
• MAC Based ACL—Select a MAC-based ACL to be bound to the interface.
• IPv4 Based ACL—Select an IPv4-Based ACL to be bound to the interface.
• IPv6 Based ACL—Select an IPv6-Based ACL to be bound to the interface.
• Permit Any Unmatched Packets—Select to enable/disable this action.
STEP 6 Click Apply. The ACL binding is modified, and the Running
Configuration file is updated.
NOTE:
If no ACL is selected, the ACL(s) that is previously bound to the interface are
unbound.
To Next Page
Loading...
