DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
67
Line Key LED Pattern
Each parameter in this section represents the call appearance state where the specified LED pattern
should apply
Parameter Name Description Type Default
Idle LED pattern during the Idle state, where the call appearance is
not is in use and is available to make a new call. Leaving this
entry blank indicates the default value of “c=g”
LedScript
Local Seized LED pattern during the Local Seized state, where this station has
seized the call appearance to prepare for a new outbound call.
Leaving this entry blank indicates the default value of “c=r”
LedScript
Local Progressing LED pattern during the Local Progressing state, where this
station is attempting on this call appearance an outgoing call that
is in proceeding (i.e. the called number is ringing). Leaving this
entry blank indicates the default value of “c=r”
LedScript
Local Ringing LED pattern during the Local Ringing state, when the call
appearance is ringing. Leaving this entry blank indicates the
default value of “c=r;p=f”
LedScript
Local Active LED pattern during the Local Active state, where the call
appearance is engaged in an active call. Leaving this entry blank
indicates the default value of “c=r”
LedScript
Local Held LED pattern during the Local Held state, where the call
appearance is held by this station. Leaving this entry blank
indicates the default value of “c=r;p=s”
LedScript
Remote Undefined LED pattern during the Remote Undefined state, where the
shared call state is undefined (the station is still waiting for the
state information from the application server). Not applicable if
the call appearance is not shared. Leaving this entry blank
indicates the default value of “c=r;p=d”
LedScript
Remote Seized LED pattern during the Remote Seized state, where the shared
call appearance is seized by another station. Not application if
the call appearance is not shared. Leaving this entry blank
indicates the default value of “c=r;p=d”
LedScript
Remote
Progressing
LED pattern during the Remote Progressing state, where
another station is attempting on this shared call appearance an
outbound call that is progressing. Not applicable if the call
appearance is not shared. Leaving this entry blank indicates the
default value of “c=r;p=d”
LedScript
Remote Ringing LED pattern during the Remote Ringing state, where the shared
call appearance is in ringing on another station. Not applicable if
the call appearance is not shared. Leaving this entry blank
indicates the default value of “c=r;p=d”
LedScript
Remote Active LED pattern during the Remote Active state, where another
station is engaged in an active call on this shared call
appearance. Not applicable is this call appearance is not shared.
Leaving this entry blank indicates the default value of “c=r;p=d”
LedScript
Remote Held LED pattern during the Remote Held state, where another station
has placed this call appearance on hold. Not applicable if the call
LedScript
To Next Page
Loading...
