Linksys SPA941 - Page 70

DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
70
NAT Settings
Parameter Name Description Type Default
NAT Mapping Enable If set to yes, the SPA will substitute private address/port
with external address/port where appropriate. Otherwise,
the SPA will use the private address/port only.
Bool No
NAT Keep Alive Enable If set to “yes”, the configured <NAT Keep Alive Msg> is
sent periodically every <NAT Keep Alive Intvl> seconds.
Bool No
NAT Keep Alive Msg Contents of the keep-alive message to be sent to a given
destination periodically to maintain the current NAT-
mapping. It could be an empty string. If value is
$NOTIFY, a NOTIFY message is sent as keep alive. If
value is $REGISTER, a REGISTER message w/o
Contact is sent. If value is $PING, a PING message is
sent. For all other values, the string is sent as specified.
Str31 $NOTIFY
NAT Keep Alive Dest Destination to send NAT keep alive messages to. If value
is $PROXY, it will be sent to the current proxy or
outbound proxy
FQDN $PROXY
Network Settings
Parameter Name Description Type Default
SIP TOS/DiffServ Value TOS/DiffServ field value in UDP IP Packets carrying a
SIP Message
Byte 0xb8
RTP TOS/DiffServ
Value
TOS/DiffServ field value in UDP IP Packets carrying a
RTP data
Byte 0xb8
Network Jitter Level 4 settings are available: very high, high, medium, low.
This parameter affects how jitter buffer size is adjusted in
the SPA. Jitter buffer size is adjusted dynamically. The
minimum jitter buffer size is 30 ms or (10 ms + current
RTP frame size), which ever is larger, for all jitter level
settings. But the starting jitter buffer size value is larger
for higher jitter levels. This parameter controls the rate at
which to adjust the jitter buffer size to reach the
minimum. If the jitter level is set to high, then the rate of
buffer size decrement is slower (more conservative), else
faster (more aggressive).
Choice High
Call Feature Settings
Parameter Name Description Type Default
Blind Attn-Xfer Enable
MOH Server
2
The User ID or URL of the auto-answering SAS to
contact for MOH services. Examples: 5000,
1001@music.linksys.com, 66.12.123.15:5061. Note:
When only a user-id is given, the current proxy or
outbound proxy will be contacted as in the making of a
Str127