11
Chapter 4: Setting up and Mounting the Wireless-G Internet Camera
Setup Wizard
Wireless-G PTZ Internet Camera with Audio
Chapter 4: Setting up and Mounting the Wireless-G
Internet Camera
Setup Wizard
The Wireless-G Internet Camera Setup Wizard will guide you through the installation and configuration procedure.
1. Insert the Setup CD-ROM into your CD-ROM drive. The Setup Wizard should run automatically, and the
Welcome screen should appear. If it does not, click the Start button and choose Run. In the field provided,
enter D:\wvc200.exe (if “D” is the letter of your CD-ROM drive).
• Setup. Click the Click Here to Start button to begin the installation process.
• Install Viewer & Recorder Utility. Click this button to install the Camera’s Viewer & Recorder Utility on
your PC.
• Setup SoloLink DDNS Service. Click the Setup SoloLink DDNS Service button to configure and use
Linksys’s Dynamic Domain Name System (DDNS) service.
• User Guide. Click this button to open the PDF file of this User Guide.
• Exit. Click the Exit button to exit the Setup Wizard.
2. Click the Click Here to Start button to begin the installation process.
3. The next screen shows the End User License Agreement. Read through this and, if you accept the terms of the
Agreement, click Next to continue.
Figure 4-2: The End User License Agreement
Figure 4-1: Setup Wizard - Welcome Screen
To Next Page
Loading...