13
Chapter 4: Setting up and Mounting the Wireless-G Internet Camera
Setup Wizard
Wireless-G PTZ Internet Camera with Audio
7. Now, check the Camera’s LEDs to verify that they’re functioning properly. Then, click Next.
8. The Wizard will now display a list of Internet Cameras on your network, along with the status information for
the Camera whose name is highlighted. In the Selection box, click the name of the Camera you are currently
installing. Write down the IP address of the Camera, so you can use it to access the Web-based Utility later.
Click the Next button.
9. For increased network security, enter a name and password for administrator access to the Camera. In
lowercase letters, enter admin in the Administrator Name and Administrator Password fields. (You can
change these settings through the Camera’s Web-based Utility later.) Then, click the OK button.
Figure 4-6: Check LEDs screen
Figure 4-7: Network Cameras Found Screen
Figure 4-8: Wizard Login Screen
To Next Page
Loading...