61
Appendix C: Upgrading Firmware
Wireless-G PTZ Internet Camera with Audio
Appendix C: Upgrading Firmware
The Camera's firmware is upgraded through the Web-based Utility's Maintenance tab. Follow these instructions:
1. Download the firmware from Linksys’s website at www.linksys.com. Then extract the file.
2. Access the Camera’s Web-based Utility, and click the Maintenance tab.
3. On the Maintenance screen, click the Firmware Upgrade button.
4. Click the Browse button to find the extracted file, and then double-click the filename.
5. Click the Start Upgrade button, and follow the on-screen instructions. Click the Cancel button to cancel the
firmware upgrade. For more information, click the Help button.
Figure C-1: Upgrade Firmware Screen
Note: Linksys recommends that you upgrade the Camera’s firmware within your network; in other
words, use a computer within the Camera’s local network. If you attempt to upgrade the Camera’s
firmware from a remote location—using a computer outside of the Camera’s local network—the
upgrade will fail.
To Next Page
Loading...