EasyManua.ls Logo

Linksys WVC200 - Figure 7-13: Options Screen

Linksys WVC200
83 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
52
Chapter 7: Using the Wireless-G Internet Camera’s Web-based Utility
Setup
Wireless-G PTZ Internet Camera with Audio
Options
The Options screen allows you to alter the Camera’s e-mail alert features, UPnP configuration, and Alternate Port
settings.
E-mail Alert
You can choose to be notified when the Camera detects motion in its field of view. You will be sent a text-only e-
mail or an e-mail with video attached.
E-mail Alert. If you want to be notified by e-mail when the Camera detects motion, then select Enable from the
drop-down menu. Otherwise, select Disable.
Send to. In each field, enter an e-mail address that will receive e-mail alerts. (You can enter up to three e-mail
addresses.)
Show “From” as. Enter the text that you want displayed in the From field of any e-mail alert message.
Subject. Enter the subject heading that you want to be used.
SMTP Mail Server. Enter the IP address of the outgoing mail SMTP server. If it requires authentication, click the
checkbox, and enter the account name and password in the Account Name and Password fields.
Pan/Tilt. This option is only available if your camera is fitted with a Pan/Tilt control. If available, select the desired
option to resolve conflict between the Pan/Tilt and Motion Detection features.
Delay between E-mails. Specify the minimum time interval between e-mail alerts. The default is 2 minutes.
E-Mail Video. If you want e-mail sent with a video attachment, select Enable from the drop-down menu. Then
select the length of video you want, up to a maximum of 5 seconds. The default is 2 seconds. If you want text-
only e-mail sent to you, select Disable from the drop-down menu.
Area/Sensitivity. Click this button to enter the motion detection sub-screen. You can set the area or areas of the
video image to be examined, and adjust the sensitivity of detection for each area.
Figure 7-13: Options Screen
NOTE: Motion detection can be triggered by rapid changes in lighting condition, as well as by
moving objects. For this reason, it should only be used indoors.

Table of Contents

Other manuals for Linksys WVC200