CONVERSION FROM MANUAL
PULL STRAP TO POWER AWNING
TI-164
AWNINGS
Fig. 6
Fig. 7
Fig. 8
7. Install new end cap to the roll tube using the three square head screws that were removed in Step 3
above. Confirm cap is fully seated on the end of the roll tube. If the screws/screw holes have been
stripped consider using #10 screws to ensure a secure fit.
8. Plug the power cord into the motor by matching the black wire from power cord to black wire at the
motor. Next take the white wire from the power cord and plug it into the red wire on the motor. Make
sure to then tuck the wires down into the mount assembly to assure wires won’t be pinched during
install (Figs 6 & 7).
9. Insert the shaft from the motor head into the end cap and secure with the provided #8 wax screw
(Fig. 8).
10. Install the head mount into the arm and secure with the bolt removed in Step 3 above.
11. Repeat Steps 3 through 6 and 8-9 for the idler head side of the awning. Cut zip ties from top of arm.
Using the cordless screw gun battery (or other low voltage battery source) run the awning out by
putting the black wire from power cord to the positive side of battery and the white wire on negative.
To Next Page
Loading...
